 |
 |
 |
|
|
|
|
|
CIP (Cast - In - Place) Process |
|
• Basic Application • Multicolor with Cobble Circle Cobblestone Field and Border • Fishscale Pattern Release Agent and Faux Brick Textured Roller |
Fishscale Pattern
Release Agent and Faux Brick Textured Roller |
|
|
|
 Stencil
Placement |
|
Fishscale stencils are installed diagonally
on the slab beginning in the middle. Stencils are rolled in and trimmed
to fit within the Soldier Course Border.  |
|
 Coloring |
|
| The base color is applied and worked
in as described in the basic application. |
|
 Release
Agent/Textured Roller Application |
|
| Release Agent containing pigment of a
complimentary color is broadcast onto the surface. Only a thin coat is
required.
A Faux Brick Texture Roller is rolled over the surface to obtain the desired
texture.. Timing of this step is important. The roller should be applied
while the surface is plastic enough to accept the texture, but stiff enough
to prevent the roller from sinking into the surface too deeply. If the
surface is too soft, wait additional time. If the surface is too stiff,
add weight to the roller by slipping a section of heavy pipe over the roller
handle. |
|
 Stencil
Removal |
|
| Stencils are removed when the surface
is set sufficient to bear weight. Do not attempt to remove the chips and
debris at this time. |
|
 Release
Agent Removal |
|
| After 24 to 48 hours has elapsed, remove
the excess release agent and debris. Begin this process by flooding with
a low pressure water hose. This will remove most of the release agent without
creating excessive dust. If
more accent color remains than is desired, use a high pressure washer to
remove additional release agent.
It may be necessary to scrub with a stiff bristle brush. In general, the
recessed areas created by the Faux Brick Textured Roller should be highlighted
by the accent of release agent color while the remaining areas show the
base color. When sufficient accent color and release agent has been removed
to give the desired affect, allow surface to dry and apply sealer as in
the basic application. |
|
|
• Basic Application • Multicolor with Cobble Circle Cobblestone Field and Border • Fishscale Pattern Release Agent and Faux Brick Textured Roller |
| Technical Information | ||
| Cast In
Place Instructions (pdf): Click Here For the free acrobat reader: Click Here |
||
| Faux Brick ® NO-ADHESIVE Stencils
are available in 1,000 sq. ft., 500 sq. ft., and 100 sq. ft. rolls and Faux Brick ® ADHESIVE Stencils are available in 500 sq. ft. and 100 sq. ft. rolls. |
||
